Teejet CenterLine User Guide v2.02 Manuel d'utilisateur télécharger pdf (Page 9)

CenterLine 2.02

98-05054 R6

CHAPTER 2 - SETUP

It is assumed that the CenterLine system has been properly installed. Refer to the following Center-

Line diagrams for system configuration.

QUICK START GUIDE

First Time Start-Up Sequence

1. Turn ON power to CenterLine.

2. The lightbar will perform a start-up sequence.

3. The lightbar will display the current software version.

4. The lightbar will display <START>.

5. Using the Arrow buttons, scroll until <SETUP> is displayed on the lightbar. Press the

Enter button.

6. Configure the CenterLine system by choosing the appropriate settings under <GUID-

ANCE>, <LIGHTBAR>, and <SYSTEM>. It is important to enter the correct swath width for

operation.

7. Use the Arrow buttons to locate <TO START>. Press the Enter button. The operator will

return to the main menu.

8. Once <START> is displayed on the lightbar, press ENTER to begin operation.

Typical Start-Up Sequence

1. Turn ON power to CenterLine.

2. The lightbar will perform a start-up sequence.

3. The lightbar will display the current software version.

4. The lightbar will display <START>.

5. <START> will remain visible on the lightbar until the Enter button is pressed to begin oper-

ation or the Arrow buttons are pressed to select a menu option.

Arrow buttons

Enter button

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 46 47

Pas de commentaire

Teejet CenterLine User Guide v2.02 Manuel d'utilisateur Page 9