Teejet BOOMPILOT JOB COMPUTER Manuel d'utilisateur télécharger pdf (Page 28)

www.teejet.com

ISOBUS Job Computer : BoomPilot

OVERVIEW SETUP APPENDIXGETTING STARTED OPERATION

AUTOMATIC OR MANUAL SECTION CONTROL

Automatic mode will turn on ABSC (automatic boom section control).

• Automatically control when boom sections are turned on/off as an applied area is entered/exited.

Manual mode will turn off ABSC. Section control will be controlled by the associated IC18.

Figure 4-6: Auto/Manual Key

1.77 B.area

5.2 0.0

0:00 hh:mm

mph

No GPS

1. On the Operation Screen , establish Automatic

Operation Mode or Manual Operation Mode by

pressing the AUTO/MANUAL key so that the green

dot is on AUTO (automatic) or the hand (manual)

accordingly.

ALL SECTIONS ON

All Sections On will turn all sections on whether you are in an applied area or not.

Figure 4-7: All On Key

1.77 B.area

5.2 0.0

0:00 hh:mm

mph

No GPS

1. On the Operation Screen , turn all sections on by

pressing the ALL ON key .

NOTE: Pressing and holding the ALL ON key will

force all sections to remain on. When you release

the ALL ON key , the sections will go back to

the previous mode (auto/manual).

1 2 ... 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Teejet BOOMPILOT JOB COMPUTER Manuel d'utilisateur Page 28