Teejet BOOMPILOT JOB COMPUTER Manuel d'utilisateur télécharger pdf (Page 17)

98-05210 R0 US

ISOBUS Job Computer : BoomPilot

OVERVIEWSETUPAPPENDIX GETTING STARTEDOPERATION

SETUP

Setup congures the GPS settings and Machine settings.

Figure 3-4: Setup

Figure 3-5: GPS Setup

Figure 3-6: Overlapping

0 %

50 %

100 %

1. From the Main Setup Screen , select SETUP.

2. Select from:

►GPS Setup – used to establish the Overlapping

percentage, GPS Alarm and GPS Input

►Machine Setup – used to establish the delay

off and delay on time; front or back implement

mounting position; and distance from the boom and

the antenna to the mounting point

GPS Setup

GPS setup establishes the Overlapping percentage, GPS

Alarm and GPS Input.

Overlapping

Overlapping determines the amount of overlap allowed

when each boom section is turned on and off using

Automatic Boom Section Control. Select from 0%, 50% or

100%.

• To select the Overlapping percentage, select an

option from the drop down menu or use the UP/

DOWN ARROWS to highlight the option.

GPS Alarm

GPS Alarm determine if an alarm sounds when GPS or

DGPS is lost or if there are no GPS alarms.

• To select the GPS alarm type, select an option

from the drop down menu or use the UP/DOWN

ARROWS to highlight the option.

GPS Input

GPS Input determines if the GPS signal is through the

internal GPS or an external RS232 port.

• To select the GPS input type, select an option

from the drop down menu or use the UP/DOWN

ARROWS to highlight the option.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Pas de commentaire

Teejet BOOMPILOT JOB COMPUTER Manuel d'utilisateur Page 17