Teejet RX370p Manuel d'utilisateur télécharger pdf (Page 10)

www.teejet.com

RX370P

PowerIng the rx370P

Connect the RX370p to a TeeJet Technologies guidance system or a 12 volt DC source with a power connector.

Refer to Appendix D for illustrations. Choosing the appropriate connector will depend on specic installation

requirements.

NOTE: Itisrecommendedthataweather-tightconnectionandconnectorbeusediftheconnectionwillbelocated

outside.

WARNING!Becarefulnottoprovideavoltagehigherthantheinputrange.Thiswilldamagethe

antenna.

The RX370p accepts an input voltage between 7 and 36 VDC via the cable. For best performance, the supplied

power should be continuous and clean.

WARNING!Donotapplyavoltagehigherthan36VDC.Thiswilldamagethereceiverandvoidthe

warranty.

The RX370p features reverse polarity protection to prevent excessive damage if the power leads are accidentally

reversed. With the application of power, the RX370p will automatically proceed through an internal start-up

sequence. However, it will be ready to communicate immediately.

NOTE: Theinitialstart-upcantakefrom5to15minutesdependinguponlocation.

NOTE: TheRX370pcantakeuptofive(5)minutesforafullionosphericmaptobereceivedfromSBAS.

OptimumaccuracywillbeobtainedoncetheRX370pisprocessingcorrectedpositionsusingcomplete

ionosphericinformation.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

Teejet RX370p Manuel d'utilisateur Page 10