Teejet GuideLine SmartPad II Manuel d'utilisateur télécharger pdf (Page 118)

3-64 Chapter 3 - Real-Time Guidance

Creating a Field Boundary

SmartPad II

Software Version 4.02

Creating a Field Boundary

SmartPad II allows you to create a map of the field boundary while applying product around the perimeter of the

field. If you want to create a field boundary map, you will need to setup SmartPad II to do so. For more information

on field boundary setup, review Chapter 2 Data Setup. A field boundary can be created in all three guidance options,

Parallel, Headland and Circle Pivot.

When SmartPad II is setup to create a field boundary, a Map Boundary button is added to the button bar in the view

page, see Figure 3-89. To start mapping the field boundary, first align the edge of the vehicle swath with the edge of

the field boundary. In the following example, SmartPad II was setup to create a field boundary off the right side of the

vehicle. Next highlight the Map Boundary button and press . Once the vehicle begins moving a line representing

the field boundary will be drawn off the right edge of the swath, see Figure 3-90. Once the key is pressed, the

lightbar will display MAP BND as well as an arrow indicating which side of the vehicle is being used to create the

boundary.

Figure 3-89: Preparing to Map Field Boundary

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 197 198

Pas de commentaire

Teejet GuideLine SmartPad II Manuel d'utilisateur Page 118