Teejet LH 1200S Manuel d'utilisateur télécharger pdf (Page 20)

LH 1200S O

PERATORS MANUAL

20 LH A

GRO

2. ENCODING BOOM SECTIONS WIDTHS

Key Operation

Press this key.

Press and hold the key for min. 5 seconds until the following is displayed:

QUANTITY CORRECTION

This display states the first value for section encodement. This value is not a

section width, but tells the monitor to deduct a value corresponding to the section

width from the litre counter when the individual section are switched off.

Only 1 or 0 can be encoded.

If 1 is encoded the monitor will reduce the litre counter by an amount

corresponding to the width of each section that has been switched off (return to

tank after the flowmeter).

If 0 is encoded no reductions will be made when sections are switched off (return

to tank before the flowmeter).

EXAMPLES:

If you are working with a sprayer fitted with a valve manifold with balanced returns,

where the volume through the flowmeter is the same, as long as the return valves

are correctly setup, regardless of whether the individual sections are open or

closed then encode 1. If 1 is not encoded the litre counter will be incorrect, and as

the area counter is also reduced, the displayed application rate (L/Ha.) will be

incorrect.

If a flowmeter is being used on a sprayer without balanced returns the amount

passing through the flowmeter is the same as the amount being sprayed, even

when boom sections are closed. If this is the case then encode 0. If 0 is not

encoded the displayed amounts will be incorrect.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Teejet LH 1200S Manuel d'utilisateur Page 20