Teejet Legacy 6000 RMS_EXT User Guide Manuel d'utilisateur télécharger pdf (Page 34)

3-2 Chapter 3 - Real-time Setup

RMS-EXT Real-Time Setup

RMS-EXT for the Legacy 6000

Software Version 2.00

RMS-EXT Real-Time Setup

This Chapter covers setting up RMS-EXT for real-time operation. Prior to starting real-time opera-

tion, we recommend that “Chapter 4 - Real-time Operation” be reviewed.

When the System Setup process is complete (see System Setup on page 2-8), real-time setup can

begin. Do this by pressing the Bull’s-eye located on the RMS-EXT Main Launcher page (Figure 3-

1). The steps in the real-time setup process vary, based on how the Legacy 6000 system is config-

ured.

Real-time Setup requires the Agency, Chemical, and Personnel profiles. These profiles are created

in RMS - Office and then exported to RMS-EXT. You cannot run Real-time setup without these pro-

files.

Real-time Setup Steps

We recommend that these setup procedures be reviewed carefully. Familiarity with job creation,

file naming, and product setup allow these setup steps to be accomplished in just a minute or two.

Table 3-1 outlines the real-time setup steps. Each step listed in the table is described in more

detail in specific sections of this chapter.

Figure 3-1: RMS Main Launcher

Operate ARM

Button

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 85 86

Pas de commentaire

Teejet Legacy 6000 RMS_EXT User Guide Manuel d'utilisateur Page 34