Teejet IC18 SPREADER JOB COMPUTER Manuel d'utilisateur télécharger pdf (Page 23)

98-05271 R0 UK

OVERVIEWSETUPAPPENDIX GETTING STARTEDOPERATION

ISOBUS Job Computer : IC18 Spreader European

HELP

The Help menu allows the operator to choose between Diagnostics and the display of information about serial number, CAN BUS

information, etc. These menus are typically accessed upon Customer Service personnel request only.

MAIN SETUP MODE MENU STRUCTURE

| | | | | |

Counters Job Parameters Machine User Interface Communication Help

Diagnostic

About

Figure 3-30: Help

Figure 3-31: Diagnostic

Figure 3-32: Test Input

1. From the Main Setup Screen , select HELP.

2. Select from:

►Diagnostic – used to troubleshoot input/output of the controller (sensor or

actuator).

►About – provides information on the console such as software version, build

number, etc.

NOTE: Settings are NOT automatically saved when selected. The

ACCEPT KEY must be selected to save the setting. Select the

ESCAPE KEY to escape without saving settings and return to

the previous menu.

Diagnostic

Diagnostic is used to troubleshoot input/output of the controller (sensor or actuator).

►Test Input – displays the input high and low values on the installed sensors.

►Test Output – allows the regulation valve to be tested at different percentages of

dutycycle..

►VT – provides information regarding the virtual terminal controller.

►TECU – provides information regarding the TECU.

Test Input

Test Input displays the input high and low values on the installed sensors.

• To reset the sensors to "0",

select TRASH CAN KEY .

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Pas de commentaire

Teejet IC18 SPREADER JOB COMPUTER Manuel d'utilisateur Page 23